Assignment 2: DIY Instructables

My DIY instructable aid was meant to be a jar opener that can be used one handed. Unfortunately, the widespread pandemic made it virtually impossible to safely enter a Home Depot or other such warehouse. The crowds weren’t being managed well and social distancing was virtually non-existent. I was able to ask a highly talented friend of mine if she could illustrate my concept for me. I told her over the phone about my idea and I even drew a (very) rough sketch of what I had in mind and sent it over to her. Not ten minutes later she sent me her conception. As you can see it is pretty amazing. She did, however, take some artistic liberties with my description, so its not a perfect one to one representation of what I had in mind. The materials and steps are as follows:

MATERIALS

Wooden Board (14x9x2) x 1

Small Wooden Blocks (3×2) x 8

Double Sided Tape (Gorilla or 3M is best) x 1 roll

Rotating Swivel Vise x 1

Glue x 1

STEPS

  1. Glue small blocks to the each corner of the board. These will serve as the legs of the board. Be sure to glue blocks onto the side of the board that you will want to face the bottom. I recommend using two blocks per corner for a total of 8 blocks, but more can be used if the user will require a higher board. These blocks will serve as the base of the board. They allow for the board to maintain contact with the surface it is on, but still provide easy access to the bottom of the board for when it needs to be moved or cleaned. Adding blocks will also add to the number of steps required for this tool, but it is very much possible.
  2. Use double sided tape on the bottom of each small block. This will provide adhesive for the board so it can stay in place when the jar lid is being removed. Every so often this may need to be replaced depending on use.
  3. Place rotating swivel vise on board. Place it in a position that will allow the user to access the vise and be able to make the rotations on the swivel.
  4. Place double sided tape onto the area where the bottom of the jar will be placed. This will also be directly next to the rotating swivel vice.
  5. Place your new jar opener where it will be used. It should be somewhere that will be readily accessible to the intended user. It should also be on a surface that will allow for maximum adhesion.
  6. Place jar between the swivel vise and adjust the grip. Adhesion at the bottom of the jar should also help keep it in place.
  7. Twist jar lid with one hand. My illustration shows a hand using a second vise, but this is not necessary.

In all the total cost of these items can be anywhere between 15-25 dollars. The largest expense is the swivel vise, but that can be a bit misleading. Most swivel vises promoted are for industrial use. The one I am recommending is more for casual use and I have seen some for as low as 8 dollars. Hope to make this a reality soon!

Leave a Reply

Create your own website, free on WordPress.com.Create your own website.
Start free